Hello,
Hopefully you can assist with an ongoing plotter output issue
This has been occuring since an upgrade to LT 2014 (from 2008).
- LT prints to a plotter (by IP).
- When the print job is set to use the plotter, the print dialogue box enters a "Not Responding" state.
- from the printer's properties, a test page can be submitted, and is output on the plotter (the plotter is OK)
- we can out wait the "Not Responding" status (about 5 minutes), and eventually can hit OK on the print job
- we found and tried the following fix
"Options Plot and Publish Tab if hide system printers is unchecked then AutoCAD will also spend time trying to find system printers" - the plotter also disappears
- We attempted finding problem paths using ProcMon, - ProcMon displayed in excess of 1.5 million events, and growing; various paths
Any assistance you can render in this issue would be greatly appreciated
Thanks,